DIY cross legged Picnic Table [Table of contents below]
Drill holes into the brace ends
Drill two 5mm pilot holes into the ends of each brace [b].
Position the holes 40mm apart horizontally and make them equal distance top and bottom and from side to side. Refer to the picture below.
TABLE OF CONTENTS
Page 08 Adding the end rails to the legs
Page 09 Drilling bolt holes through the crosses
Page 10 Drilling holes into the ends of the braces
Page 11 Fixing the brace members in place
Page 12 Just the tabletop and bench top boards to go
Page 13 Done!
Page 14 User comments/photos