DIY cross legged Picnic Table [Table of contents below]
Drill bolt holes through the crosses
Mark and drill two 8mm bolt holes through the center of each crossing. Position the holes 40mm apart horizontally. Refer to the drawing below.
For the bench, position the top hole 25mm below the bottom of the cross-rail.
For the table, position the holes central at each crossing, both horizontally and vertically.
TABLE OF CONTENTS
Page 08 Adding the end rails to the legs
Page 09 Drilling bolt holes through the crosses
Page 10 Drilling holes into the ends of the braces
Page 11 Fixing the brace members in place
Page 12 Just the tabletop and bench top boards to go
Page 13 Done!
Page 14 User comments/photos