Novice Lady Woodworkers
Build a kids table and bench By Les Kenny
Step 1. Cut the pieces to length
Cut all the pieces to length according to the cutting on the previous page.
There is also a drawing of every piece.
Always cut the longest pieces first to minimize wastage.
Step 2. Drill screw holes through the side boards
Drill screw holes through the side boards, two at the top and two at the bottom of each piece.
Make the holes the same width as the screw.
Make the top holes 20mm down from the top and 12mm in from each side.
Make the bottom holes 35mm up from the bottom and 12mm in from each side.
TABLE OF CONTENTS
Page 01 Introduction, required tools, before you start note
Page 02 The parts and cutting list
Page 03 Step 1 & 2. Cut the pieces and drill the side boards
Page 04 Step 3. Mark position for the first side board
Page 05 Step 4. Fix the first side board
Page 06 Step 5 & 6. Add and fix the remaining side boards
Page 07 Step 7. Prepare the table top and seat top
Page 08 Step 8. Clamp the sides to the tops
Page 09 Step 9. Add the braces and it's all done