Build a kids table and bench By Les Kenny
Step 2. Drilling screw holes
Screw holes had to be drilled at each end of all the side pieces according to positions given in the instructions.
Rose was also a novice with a power drill, and although she was a bit slow to start, she had it mastered by the finish.
Using it (the power drill) to make the miter box previously also gave her a bit of practice.
Step 3. Marking side board positions
Referring to the plans and instructions Rose marked for the middle side board on the table top rails and footers, and also the center of the bench top rails and footers.
There are three vertical boards each side of the table but only two vertical boards each side of the bench, so
the table sides and bench sides have to be marked differently.
It did take a little bit of plan concentration.
TABLE OF CONTENTS
Page 01 Roses story
Page 02 Preparation and cutting the pieces
Page 03 Step 2 & 3. Drilling screw holes and marking for the side boards
Page 04 Step 4 & 5. Placing the side boards on the top rails and footers
Page 05 Step 6 & 7. Fixing the side boards and preparing the table and seat tops
Page 06 Step 8 & 9. Clamping and fixing the sides to the tops and adding the braces