Build an Adirondack chair By Les Kenny[Table of contents are below]
9. Prepare and add the seat slats
The seat slats should be spaced apart a minimum of 6mm.
A way to keep the gap (between the slats) uniform is to first make up the seat slat configuration on a flat surface prior to placing it in position on the seat.
This can be done as shown in the following steps.
Place 15 seat slats in line with one side against a straight edge.
Place two 6mm spacers between each slat, one each side. The spacers can be cut out of any 6mm board or sheet.
Ensure that the overall configuration is square and parallel.
Place a weight each end to hold the slats in place.
With weights at each end to hold it in place, as shown in the picture,
run duct tape (or similar) along each side. Let the tape run past and then trim the ends flush with a craft knife.
You will want a tape that is strong, adheres well to wood, doesn't stretch, and will peel off without tearing.
Press the tape hard to the slats to ensure good holding. [c] Remove the spacers.
[d] Apply a thick bead of glue along the top edge of the side pieces.
Pick up the seat slat configuration and place it on top of the side pieces.
Important! Make the bottom of the first seat slat flush with the bottom of the front of the side pieces.
When spread out along the side pieces, the seat slat configuration will automatically be in the right place and all the gaps will be uniform.
Screw the seat slats
When the seat slates are placed, commence screwing them.
One screw each side of each slat.
Screw through the slat into the side piece. Pre-drill the screw hole through the slat first but do not drill any further than the thickness of the slat. That means, don't drill into the side piece.
Start with the first front seat slat and continue one by one until all done.
TABLE OF CONTENTS
Page 01 Measurements, Materials list, required tools, the wood, The parts
Page 02 Cutting all the pieces to length
Page 03 Cutting the seat slats
Page 04 Cutting the back boards
Page 05 Shaping the sides
Page 06 Marking the seat curve
Page 07 Marking the seat curve (photos)
Page 08 Marking, cutting, the middle rail
Page 09 Marking and cutting the bottom rail, the arms, and corbel
Page 11 Adding the bottom rail
Page 12 Adding the legs, props, and corbels
Page 13 Adding the arms and middle rail to the mix
Page 14 Adding the back boards
Page 15 Preparing and adding the seat slats
Page 16 Shaping the back
Page 17 Photos. Touch up and sand
Page 18 Photo. Not a bad chair eh?
• User Comments/photos