Build an Adirondack chair By Les Kenny[Table of contents are below]
2.3. The bottom rail
The bottom rail is shaped out of a piece of 150mm x 25mm board, 434mm long.
Measure and mark the cutting line according to the plan drawing below.
Secure the piece to your work surface by way of clamp or other.
Ensure the part to be cut off is overhanging the work surface or is clear of anything that could obstruct the cutting blade.
Unlike the middle rail, this is a square cut so the blade on the jig-saw will be set to straight up and down (normal).
2.4. The arms and corbels
The arms are shaped from a couple of pieces 150x25 @ 746mm long, and the corbels are shaped from a couple of pieces 150x25 @ 200mm long.
Refer to the drawing below to mark the arms and corbels for cutting.
Then cut them out.
Do do this, secure the pieces to your work surface by way of clamp or other.
Ensure the part to be cut off is overhanging the work surface or is clear of anything that could obstruct a cutting blade.
Holding the saw firmly, and ensuring you are on good footing and comfortable, proceed with the cut.
Likewise do the arm corbels.
TABLE OF CONTENTS
Page 01 Measurements, Materials list, required tools, the wood, The parts
Page 02 Cutting all the pieces to length
Page 03 Cutting the seat slats
Page 04 Cutting the back boards
Page 05 Shaping the sides
Page 06 Marking the seat curve
Page 07 Marking the seat curve (photos)
Page 08 Marking, cutting, the middle rail
Page 09 Marking and cutting the bottom rail, the arms, and corbel
Page 11 Adding the bottom rail
Page 12 Adding the legs, props, and corbels
Page 13 Adding the arms and middle rail to the mix
Page 14 Adding the back boards
Page 15 Preparing and adding the seat slats
Page 16 Shaping the back
Page 17 Photos. Touch up and sand
Page 18 Photo. Not a bad chair eh?
• User Comments/photos